F10

BREDAL F8 and F10 are Bredal's trailed fertilizer spreaders intended for professional use, where high demands are placed on efficiency and profitability. These models have been developed to meet the various requirements for graduated fertilising, boundary spreading, wedge spreading, residual width spreading and automatic start and stop in the headland.

‍

The trailed fertilizer spreader is prepared for ISOBUS as standard with a newly developed and thoroughly tested software. Other standard equipment for F8 and F10 can include mention is made of  "A" plates for  spreading commercial fertiliser , an  SPC4500-2 spreader with 24-36 meter edge gear for  edge spreading and then the spreader is standard with  section control .

‍

F8 and F10 can be equipped with load cells, which means that the spreader itself keeps track of the dosage, that it is correct in relation to the coded desired quantity.

‍

In addition, a tilt sensor is built in as standard that regulates the dosage in hilly terrain.

‍

The spreader is built with 2 belts that are controlled independently of each other, so that it is possible to dose different amounts on the right and left side.

‍

The 2 downspouts that place the fertilizer on the 2 spreading plates are controlled individually on the right and left side, which means that an optimal spreading pattern is achieved with varying working widths and dosages.

‍

An automatic flow correction is built into the downspout management software, so that the downspout position automatically adapts to the current seed quantity, this means in practice that there are no changes in the spreading pattern, regardless of whether you run with a small or large quantity.

‍

F8/F10 are available with either a red lacquered or stainless steel box and with different tire mountings and track widths.

‍

F8 is available as standard with a 5.70 m3 container and F10 with 6.60 m3.

‍